Engine Cooling Fan – Is Yours Working

0
25


The only runs when needed to help cool the engine.

A engine cooling fan failure, or a failure of the fan relay or control circuit is bad news because it can allow the engine to overheat.

Engine Cooling Fan
Engine Cooling Fan

The engine coolant sensor or a separate engine temperature switch is used to monitor engine temperature.

Extra cooling is not needed when a cold engine is first started, so the engine cooling fan does not come on until the engine reaches normal operating temperature.

The fan will then cycle on and off as needed to maintain the proper coolant temperature.

So, The fan runs mostly at idle or low speed when the engine is at normal temperature.

Most fans should come on when the coolant reaches about 200 to 230 degrees.

Let’s Start With Some Easy Questions:

If Not , Let’s Do Some Testing And Try To Fix It Yourself

The first step is checking for a blown fuse.

Blown Fuse
Blown Fuse

Your engine cooling fan will not work if you have a blown fuse. In general, most vehicles on the road have two types of fuses. Older cars have glass, cylinder-shaped fuses with stainless steel on the ends and glass in the middle. Most newer cars have a different style of fuse that uses a plastic housing with the fusible link encased in the housing. One easy way is just  visually check for a continuous wire with no breaks. Using a multimeter is another good way.

So, If you find a Blown Fuse replace it. That may be all you need to get back on the road.

If The Fuse Is OK Move On To The Next Step.


Engine Cooling Fans can and do wear out. Yours could be blown so you will need to check it.

Cooling Fan
Cooling Fan

Unplug the Fan Connector closest to the fan.

Make up some jumper cables and connect them directly from the battery to the fan motor to see if it spins.

Consequently if it does not spin it is blown. Replace it and you are back on the road.

If It Is OK Move On To The Next Step.


Engine Cooling Fan Issues.

A fan failure, or a failure of the fan relay or control circuit is bad news because it can allow the engine to overheat. On applications that have variable fan speed, the engine may also overheat if fan speed fails to increase when additional cooling is needed. The fan may work but it only runs at low speed, which may not be fast enough to prevent overheating.

In general there are six things may prevent an electric cooling fan from coming on:

  • Defective temperature switch, coolant sensor or other sensor
  • Engine thermostat is stuck OPEN (engine never gets hot enough to turn on the fan)
  • Faulty fan relay
  • A wiring problem (blown fuse, loose or corroded connector, shorts, opens, etc.)
  • A bad fan motor
  • Defective fan control module

The Next Thing To Test Is The Coolant Switch Or Sensor

On most systems, there is a coolant temperature switch that turns the fans on and off.

Locate the coolant temperature switch and unplug it. Be sure you have the right one. Some vehicles have as many as three:

  • One for a dashboard warning light
  • Or an overhead console
  • One for the PCM
Engine Coolant Temperature Sensor-(ECT)
Engine Coolant Temperature Sensor-(ECT)

Consequently with the engine running and the coolant temperature switch unplugged the fan should come on. The PCM will now detect a failed switch, store a Diagnostic Trouble Code (DTC) and turn on the fan(s).

If it doesn’t, and you have a domestic vehicle, the coolant temperature switch is a normally open type that stays open until the coolant reaches its set temperature. When it reaches that temperature, the switch closes and turns the fan(s) on.

To check this, unplug the single wire connector and, using a jumper wire, ground it. At this point the fan should come on. Most Japanese cars have a normally closed switch. These switches open when the set temperature is reached thus turning the fan(s) on.

Conclusion

The cooling fan motors are an important component to any engine cooling fan assembly, and play a key role in keeping the car at safe temperatures during idle and low speeds.

In conclusion if you suspect that your cooling fan motors may be having an issue, start doing some testing to see if you can fix it yourself.

PLEASE SHARE ENGINE PORTAL NEWS



Source link

LEAVE A REPLY

Please enter your comment!
Please enter your name here